I just install OpenWRT on my TP-LINK ER605 after struggling to get IPv6 working. IPv6 started working immediately after installing OpenWRT, but I wasn't able to get an IPv4 address. The stock settings have both wan and wan6 interfaces, both aliases for eth0. I discovered that if I take down the wan6 interface the wan interface immediately comes on-line with a valid IPv4 address, but when I bring wan6 back up it hangs and never gets an IPv6 address. If I bring wan down wan6 comes back online. In other words I can get the router working with IPv4 or IPv6 but not both. Any ideas on how I can get both working at the same time?
Statistics: Posted by schmidtc — Sat Jul 27, 2024 2:17 pm